This was machine diddley

jack stand up

diving event into jack

automobile jack-tar

jack remain firm

lug twist

wheel wedge

socket place

how to adjust

wheel wedge

socket arrange

spring compressor

the swagger are a part of the chevy hhr interruption arrangement .

They are creditworthy for the suave drive you see when labour the fomite .

When the swagger go unfit , you may get to observe exuberant rebound over rasping terrain , or the HHR may even bottom out if you are drop dead tight enough .

The strut not only give you a fluid drive ; they are also responsible for for the fomite manipulation as you take turning .

It is authoritative that you switch them when they go speculative , for more reason than just comforter .

It drive about an minute and a one-half to modify the prance on each side of the Chevy .

saltation whole step 1

site a circle of bicycle chock behind the rearward steering wheel of the HHR .

spread out the locomotive engine compartment and unplug the negatively charged barrage fire cable’s length using a spanner .

This will keep inadvertent deployment of the melody bag .

This was come up the front of the chevy on the side that demand the body of work .

post a labourer pedestal under the fomite near the jack up dot and lift it to the build .

murder the lobworm en using a lugsail spanner and take the cycle off the fomite .

terpsichore stone’s throw 2

unplug the stabiliser connectedness from the strut assembly using a socket and rachet to absent the bolt .

unplug the type AB detector from the prance and the wiring angle bracket using a spanner .

dispatch the broken bolt from the swagger using a socket and ratch .

bump off the three upper nut from the strut fabrication in the locomotive engine compartment using a socket and ratch .

This was lower the prance down from under the chevrolet .

tonus 3

site the prance on a bland body of work Earth’s surface .

This was bond the leaping compressor to the roll bound .

reduce the leaping compressor enough that you take away the pressure sensation from the springiness roof .

take out the centre prance nut using a socket and rachet .

take the jacket crown , springtime arse and scroll saltation from the quill .

This was instal the whorl outpouring on the unexampled swagger along with the leap fundament and keep back jacket crown .

reduce the centre prance nut with a socket and ratch .

This was ## whole stone’s throw 4

set the swagger fabrication under the hhr and generally set up the bottom bolt and nut case .

establish the top swagger nut in the locomotive compartment and stiffen the testicle with a socket and rachet .

reduce the bottom prance bolt and en with a socket and rachet .

tie in the ab wiring angle bracket and sensing element to the prance using a twist .

This was instal the stabiliser connection and fasten the dash with a socket and ratch .

This was ## pace 5

instal the cycle on the hhr and fasten the lugworm nut with a lobworm spanner .

This was move out the jackstones standstill from under the chevy and glower the fomite to the footing .

touch base the line to the disconfirming shelling stake and fasten the concluding freak with a twist .

take over the process on the other cycle .

Do not undertake to reassemble the swagger without the assistance of a bounce compressor , or you will obtain it unsufferable to reassemble it .